4 Tips on Using a Blind Spot Monitoring System
Adding a blind spot monitoring system to vehicles as part of your dashboard fleet management can increase overall safety. However, drivers need to be aware of its advantages and disadvantages. The system only acts as an aid and should not be relied upon completely. In this article, learn four tips on how to properly utilise a blind spot monitoring system.
Clean the Cameras and Sensors Often
Make it a habit to inspect blind spot detection sensors for any buildup of dirt, mud, and other things that might stick to them after driving. As dirt piles up on the equipment, its detection capabilities become increasingly unreliable. It can even stop working reliably in the worst cases. If left alone, it can cause accidents in the future due to faulty detection. Always check the cameras and sensors for dirt before and after travelling.
Check the Manual for Proper Setup
To get the most out of a blind spot monitoring system, read the manual to know the proper way how to install it to the vehicle. Aside from the correct setup instructions, the manual can inform you of anything you need to know about the system and how to care for it.
Be Aware of the System’s Limitations
Remember that your blind spot detection sensor has its limitations. Even under the best condition, it can fail. Aside from that, you need to be aware of how it works. Some blind spot monitoring systems work when the vehicle is at a certain speed. Reading the manual can inform you of the system’s limits.
Use Your Eyes
Your eyes are still your best option when it comes to avoiding accidents. Before switching lanes, always check if it is safe. Your blind spot monitoring system can only do so much. As much as possible, drive carefully as if the system is not there.
If you are looking for a driver monitoring system, contact Guardian South East Asia for more information.
